![]() ![]() Returns 1 if full functionnality mode, 0 if minimal (check if gpio pins 4/6 are correctly set in rc. The last line switch modem in RNDIS mode, you will discover a new entry in ifconfig.Ĭommonly used commands (for more go to ) : ATI You may need to provide APN & other settings to connect to Internet through your provider (next example is for Orange in France) : AT+CGDCONT=1,"IPV4V6","orange","",0,0,0,0 Minicom -D /dev/ttyAMA0 # for Raspberry Pi 2B / Zero Now, it’s time to chat with your SIM7600 card : minicom -D /dev/ttyS0 # for Raspberry Pi 3 In your /etc/rc.local, you can add this line before “exit 0” : /home/pi/SIM7600X-4G-HAT-Demo/Raspberry/c/sim7600_4G_hat_initīut when you will issue a reboot, you can not use your 4G card anymore.įor this, you need to add in a new file /etc/rc6.d/K00_sim7600_hat_stop : echo "1" > /sys/class/gpio/gpio4/value Sudo chmod a+x /home/pi/SIM7600X-4G-HAT-Demo/Raspberry/c/sim7600_4G_hat_init Get file package from Waveshare with this code : wget ħz x SIM7600X-4G-HAT-Demo.7z -r -o/home/pi Install minicom to be able to send command to SIM7600 card later : sudo apt-get update Hit Yes at question “Would you like the serial port to be enabled?”.Hit No at question “Would you like a login shell to be accessible over serial?”.Connect 4G LTE Antenna to SIM7600 MAIN connectorĮnable Rasperry Pi serial interface : sudo raspi-config.Connect SIM7600 USB port (not USB-to-UART) to one available USB port on Raspberry.My card is an old card, on newer card you still have 3V3 with PWR pins and another jumper between D4 and flight After connection ,press CTRL+D to initiate soft reboot and then press CTRL+B to exit to MicroPython instance. Keep yellow jumper between 3V3 and VCCIO pins on the yellow jumpers. Once COM port number is known, we can open our WSL instance and start the connection with minicom -D /dev/ttyS3 by replacing ttyS3 with respective of COM port.Keep yellow UART jumpers on B mode on SIM7600 card.After long hours to find right to solution to connect my Waveshare SIM7600, here are my settings that works :
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |